Not Connected ((new)) - 917-front Audio

The error is triggered by a continuity check performed by the motherboard. If the circuit isn't completed, the BIOS assumes the hardware is missing or broken.

Note: Some HP models do not allow you to disable this specific error check; in those cases, a physical jumper is required. 4. Clear the CMOS 917-front audio not connected

Sometimes the BIOS "hangs" on a hardware state that no longer exists. Locate the CMOS button (usually yellow) on the motherboard. Hold it for 5–10 seconds with the power off. Restart the system to see if the hardware is re-detected. The error is triggered by a continuity check

A physical break in the front audio jack or the cable itself. Hold it for 5–10 seconds with the power off

The cable connecting the front ports to the motherboard has wiggled free.

If you don't use the front audio ports and want the message gone: Restart the PC and tap to enter BIOS Setup. Navigate to Advanced > Device Options . Look for Front Panel Audio and set it to Disabled .