Annoy Tools Cnc Board Manual Pdf -

The Annoy Tools board typically serves as an interface between an or Uno and A4988 or DRV8825 stepper motor drivers. It translates G-code commands into physical movement. Key Specifications Voltage: 12V–36V DC input. Axes: Supports 3-axis (X, Y, Z) plus a clone axis (A). Firmware: Compatible with GRBL 0.8, 0.9, and 1.1. Interface: USB connection via the Arduino microcontroller. 🔌 Hardware Installation

Invert the mask in GRBL settings ($3=n) or flip the motor plug 180 degrees. 📜 Safety & Maintenance annoy tools cnc board manual pdf

Check wire continuity or increase current via the driver potentiometer. The Annoy Tools board typically serves as an

Place jumpers under the driver seats to set Microstepping (usually all 3 jumpers for 1/16 step). Axes: Supports 3-axis (X, Y, Z) plus a clone axis (A)

Ensure the correct COM port and 115200 baud rate are selected.

Proper hardware setup is critical to prevent "magic smoke" (short-circuiting).

Turn on logic (USB) before applying high-voltage motor power.