Insert the center selector rod through the plates and attach the cable end to the top of the rod.
Tighten all bolts from Step 1 through Step 3. If the cables feel too loose, adjust the floating pulley bracket position or use the chain links usually provided at the cable ends to take up the slack. Safety & Maintenance dp dual trac 20 assembly instructions full
Start at the lat bar attachment point. Thread the cable over the top pulleys, down through the "floating" pulley block, and back up to the anchor point on the frame. Insert the center selector rod through the plates
Secure the seat and backrest pads to their respective frames using the smaller hex bolts. Safety & Maintenance Start at the lat bar attachment point
Lift the top horizontal frame piece onto the vertical upright. Secure it with the heavy-duty bolts and washers.
Run the handles through a full range of motion without any weight plates pinned to ensure the cables are tracking correctly.