New — Gilbarco Dispenser Twowire Protocol For Third Party Pump Controllers

The protocol follows a architecture. The pump controller (Master) initiates all communication by polling the dispensers (Slaves). Every unit on the loop receives the data, but only the specific unit addressed responds, while others ignore the message. Interface Requirements for Third-Party Systems

Understanding the Gilbarco Dispenser Two-Wire Protocol The is a proprietary communication standard used to interface Gilbarco fuel dispensers with Point-of-Sale (POS) systems and third-party pump controllers . It operates on a current loop principle, traditionally at 45 mA , although variants like 20 mA or 60 mA may be encountered depending on the specific hardware. Core Technical Specifications The protocol follows a architecture

Uses an 11-bit data format for maximum throughput. Typically 5787 bps , though some configurations may

Typically 5787 bps , though some configurations may use 4800 bps. Data Format: 8 Data bits, Even Parity , and 1 Stop bit. Typically 5787 bps