Plug the AC power adapter into the camera and a non-switched outlet. Wait approximately 2–3 minutes for the camera to boot. The status LED should begin to , indicating it is ready for Wi-Fi configuration.
Follow the on-screen instructions in the portal to scan for and select your home's 2.4 GHz Wi-Fi network. Enter your network password when prompted. The camera's LED will turn once it has successfully connected to the internet. 5. Add the Camera to Your Alarm.com Account http v515 install
With the camera online (solid green LED), you must link it to your security account: 1080p Indoor Wi-Fi Camera Installation Guide - Surety Plug the AC power adapter into the camera
Open a web browser on the same device and enter http://v515install or http://v515install.com into the URL field. This will launch the camera's internal setup page. 4. Join Your Home Wi-Fi Follow the on-screen instructions in the portal to
Troubleshooting : If the LED is not blinking white after two minutes, hold the for about 6 seconds until it begins to blink. 2. Connect to the Camera's Temporary Wi-Fi
The "http://v515install" URL is a critical web-based interface used to set up the Alarm.com ADC-V515 1080p Indoor Wi-Fi Camera Go to product viewer dialog for this item.
: A 2.4 GHz Wi-Fi connection. Note that the does not support 5 GHz networks.