Satlink WS-6906 Software Upgrade: The Complete Guide to Improving Your Satellite Meter
The WS-6906 typically uses a 3.5mm jack to RS232 (DB9) cable. If your laptop doesn't have a serial port, you will need a USB-to-RS232 adapter .
Connect the 3.5mm jack into the "Data Port" on the side of the Satlink WS-6906 and the RS232 end into your computer. 3. Configure the Upgrade Tool satlink ws6906 software upgrade
Open your upgrade software on the PC. You will need to select the correct (usually found in your PC’s Device Manager). Set the "Operate Mode" to "Upgrade" and select the firmware file you downloaded. 4. The Flash Process Keep the Satlink WS-6906 OFF initially. Click "Start" on the PC software. Turn the Satlink power switch to ON .
This is usually a COM port issue. Check your USB-to-Serial drivers or try a different USB port. Satlink WS-6906 Software Upgrade: The Complete Guide to
Newer updates sometimes add more interface languages for global users. Prerequisites Before Upgrading
If a flash fails, the device may appear dead. You may need to perform a "blind flash" or use a specialized recovery tool if the bootloader is still intact. Conclusion Set the "Operate Mode" to "Upgrade" and select
Firmware is usually a .bin or .abs file.