The V2000-C is a single-door multifunction standalone access controller. It supports up to and allows access via RFID card, a 4-to-6 digit PIN, or a combination of both. Operating Voltage: DC 12V ± 10% User Capacity: 2,500 Card Reading Distance: 3–6 cm Active Current: Lock Output Load: Max 3A Operating Temperature: -45°C ~ 60°C 2. Installation and Wiring
Enter programming mode, then press 0 + [New 6-digit Code] + # + [Repeat New Code] + # . 4. User Management Adding Users (Card or PIN) Enter Programming Mode. Press 1 . For Card: Swipe the RFID card.
Enter a unique User ID (1-2500) + # + [4-6 digit PIN] + # . Press * to exit. Deleting Users Enter Programming Mode. Press 2 . By Card: Swipe the card you wish to delete. By ID: Enter the User ID + # . Press * to exit. 5. Advanced Settings Door Relay Time
To adjust how long the door remains unlocked (0-99 seconds): Enter Programming Mode. Press 4 + [0-99] + # . (Default is 5 seconds). Access Mode Configuration You can choose how users authenticate: Press 3 + 0 + # Card OR PIN: Press 3 + 1 + # (Default) Card + PIN: Press 3 + 2 + # 6. Resetting to Factory Defaults
Check for a short circuit in the wiring or an "anti-tamper" alarm trigger.
V2000-c Rfid Access Control User Manual ❲Verified❳
The V2000-C is a single-door multifunction standalone access controller. It supports up to and allows access via RFID card, a 4-to-6 digit PIN, or a combination of both. Operating Voltage: DC 12V ± 10% User Capacity: 2,500 Card Reading Distance: 3–6 cm Active Current: Lock Output Load: Max 3A Operating Temperature: -45°C ~ 60°C 2. Installation and Wiring
Enter programming mode, then press 0 + [New 6-digit Code] + # + [Repeat New Code] + # . 4. User Management Adding Users (Card or PIN) Enter Programming Mode. Press 1 . For Card: Swipe the RFID card. V2000-c Rfid Access Control User Manual
Enter a unique User ID (1-2500) + # + [4-6 digit PIN] + # . Press * to exit. Deleting Users Enter Programming Mode. Press 2 . By Card: Swipe the card you wish to delete. By ID: Enter the User ID + # . Press * to exit. 5. Advanced Settings Door Relay Time The V2000-C is a single-door multifunction standalone access
To adjust how long the door remains unlocked (0-99 seconds): Enter Programming Mode. Press 4 + [0-99] + # . (Default is 5 seconds). Access Mode Configuration You can choose how users authenticate: Press 3 + 0 + # Card OR PIN: Press 3 + 1 + # (Default) Card + PIN: Press 3 + 2 + # 6. Resetting to Factory Defaults Installation and Wiring Enter programming mode, then press
Check for a short circuit in the wiring or an "anti-tamper" alarm trigger.
